You can do this in one of two ways: Connect with WPS. Connect to an Existing wifi Network To extend the Range of your wifi network, you must connect the Extender to your existing wifi network. If the Status LED does not light, press the Power button. Plug the Extender into an electrical outlet. Note: Proximity to the wifi router is required only during the initial setup process. Place the Extender and Apply Power 1.Ĥ Place your Extender in the same room as your wifi router. Install the Extender Place the Extender, apply power, and connect it to your wifi network. The Extender is not connected to a computer or mobile device. The Extender is connected to a computer or mobile device. Device to This LED indicates the connection between the Extender Extender LED and a computer or mobile device. Link Rate LED This LED indicates the connection between the Extender and the router or access point. LED Descriptions Use the LEDs during Installation to find the best location for the Extender or to monitor the Extender performance. Rear Panel Restore Factory Settings button Ethernet ports Power input Power On/Off button 4. Meet Your Extender Before you install your Extender, familiarize yourself with its LEDs, buttons, and ports.Ģ Front Panel Link Rate LED. Existing wifi Sometimes your router does not provide the wifi coverage you need. wifi Range Extender Boosts the Range of your existing wifi and creates a stronger signal in hard-to-reach areas. An Extender repeats the signals from an existing wifi router or access point. Your extender is now extending your network's coverage.1 WN2000 RPT wifi Range Extender Installation Guide Getting Started The NETGEAR wifi Range Extender increases the distance of a wifi network by boosting the existing wifi signal and enhancing the overall signal quality over long distances. Go back to your web browser, select the checkbox at the bottom of the page, and click or tap CONTINUE. On a device that you plan to connect to the extender network, go to the WiFi settings and connect to the extender's new network.The extender displays the WiFi network name (SSID) and password for each of your extender's bands. This allows your extender to use the same WiFi name (SSID) and password as your existing WiFi network. Select the Enable One WiFi Name check box to enable this feature if your extender supports it. (Optional) For mesh extenders, you have an option to use the same WiFi name and password as your existing network.By default, the password for each band is the same as your existing network. Select SSIDs and passwords for your extender.īy default, the extender uses the name of your existing network with _2GEXT added to the end for the 2.4GHz band and _5GEXT for the 5GHz band.Enter your existing network's password and click or tap NEXT.If you do not see your networks, click or tap See More. Select the radio buttons for your network's 2.4GHz and 5GHz WiFi Network Names (SSID).Your extender searches for local WiFi networks. If your extender asks if you would like to use the NETGEAR Genie to help, click or tap YES or CONTINUE. These questions are used to recover your extender's admin credentials if you forget them. Select and answer two security questions from the drop-down menus.We recommend leaving the default User Name as admin and choosing a password that is different from your WiFi network password. These credentials are used to access your extender's settings on a web browser.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |